|
11 standard functions for the control of P & T motors and zoom lenses, 6 functions for auxiliary services telemetry data (2x dry contacts, 1x 12Vdc, 1x 24Vac, wiper and washer) |
|
Maintenance of configuration even in case of power loss |
|
Up to 14 presets |
|
4 alarminputs, (prepositioning in case of alarm) |
|
Preset Autotest functions |
|
Selection of the pan & tilt power supply (24Vac or 230Vac) and camera (12Vdc or 24Vac) |
|
RS232, Current Loop, RS485 or over the Coax (with optional card DTCOAX) selectable communication |
|
Available version 24Vac (DTRX324) |
| |
|
General |
|
17 Functions: UP, DOWN, LEFT, RIGHT, AUTO, WASHER, WIPER, ZOOM TELE, ZOOM WIDE, FOCUS NEAR, FOCUS FAR, IRIS OPEN, IRIS CLOSE, AUX1, AUX2, AUX3, AUX4 |
|
999 selectable address through Dip Switches |
|
Serial input selectable: RS232 / Current Loop / RS485 |
|
Repeater RS232, RS485 or Current Loop for daisy chain configuration |
|
Ability to use both polarity inversion lenses and common wire lenses |
|
LED indicating power supplied to the unit |
|
LED indicating active function |
|
EEPROM for the storage of active options |
|
16 bit microcontroller with re-programmable Flash memory |
|
PRESET / SCAN / PATROL functions with an automatic recognition of the existing functions |
|
Self-test installation procedure |
|
Ability to memorize up to 40 PRESET functions (P&T motor, lens) |
|
4 alarm contacts set as N.O. or N.C. |
|
Supplied with instruction manual, 2 PG11 blanking caps, 4 wall mounts with relevant fastening screws |
| |
|
Mechanical |
|
Plastic material enclosure |
|
6 cable glands PG11 |
|
External dimensions: 337x237x128mm (13.2x9.3x5in) |
| |
|
Compliance To |
|
CE according to EN 61000-6-3, EN 60065, EN 50130-4 |
|
IP56 |
